Spring Lock Couplings: Connect
WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect and clean both coupling ends. Install new O-ring seals and garter springs if necessary.
- Lubricate the O-ring seals with clean engine oil.
- Fit the male fitting into the female end and push until the garter spring snaps over the flared end of the female fitting.
- Make sure the coupling is engaged by pulling on the lines and install the safety clip.