Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .

CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.

Turn the ignition switch to the OFF position.

NOTE: The crankshaft position (CKP) sensor is located underneath the air conditioning compressor.

Remove the nut and position the positive battery cable and support bracket aside.
- To install, tighten to 30 Nm (22 lb-ft).
  
  Fig 1: Locating Battery Cable And Support Bracket Nut
  Courtesy of FORD MOTOR CO.
Remove the bolt and position the battery negative cable aside.
- To install, tighten to 47 Nm (35 lb-ft).
  
  Fig 2: Locating Battery Negative Cable Bolt
  Courtesy of FORD MOTOR CO.
Disconnect the CKP sensor electrical connector.
Remove the bolt, the CKP sensor and discard the O-ring seal.
- To install, tighten to 13 Nm (10 lb-ft).

NOTE: Apply clean engine oil to the O-ring seal prior to installation.

To install, reverse the removal procedure.
- Install a new O-ring seal.