Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.

Turn the ignition switch to the OFF position.

CAUTION: Use care when removing the instrument panel steering column cover or damage to the cover locating tab can occur.

Remove the instrument panel steering column cover.
1. Unlock the retainers.
2. Remove the instrument panel steering column cover.
  
  Fig 1: Identifying Instrument Panel Steering Column Cover And Retainers
  Courtesy of FORD MOTOR CO.
Remove the barometric pressure (BARO) sensor.
- Disconnect the BARO sensor electrical connector.
- Release the clip and remove the BARO sensor.
  
  Fig 2: Locating BARO Sensor Electrical Connector
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.