Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford Cutaway, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Fuel Pump Driver Module (FPDM) Remove/Install Components

Courtesy of FORD MOTOR CO.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
Disconnect the fuel pump driver module (FPDM) electrical connector.
Remove the FPDM nuts.
- To install, tighten to 10 Nm (89 lb-in).
Remove the FPDM.
To install, reverse the removal procedure.