LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 625 (Manual Transmission - F250-F550) >> In-Vehicle Repair >> Output Shaft Seal >> Installation

Output Shaft Seal: Installation

WARNING: This page is about a different car, the 2006 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

    Vehicles with four wheel drive (4WD) 

  1. Using the special tool, install a new output oil seal.
    • Coat the outer diameter of the new seal with gasket and trim adhesive.
      Fig 1: Identifying Special Tool
      G04650386Courtesy of FORD MOTOR CO.
  2. Install the transfer case. For additional information, refer to TRANSFER CASE .

    3. Vehicles with rear wheel drive (RWD) 

  3. Using the special tool, install a new output oil seal.
    • Coat the outer diameter of the new seal with gasket and trim adhesive.
      Fig 2: Installing Output Oil Seal
      G04650387Courtesy of FORD MOTOR CO.
  4. Apply Threadlock 262 to the threads of the transmission flange locknut. Using the special tools, install the transmission flange.
    • Tighten to 330 Nm (244 lb-ft).
      Fig 3: Identifying Special Tools
      G04650388Courtesy of FORD MOTOR CO.

    5. All vehicles 

  5. Connect the rear driveshaft. For additional information, refer to DRIVESHAFT .
scientia non olet · About LEMON Manuals