LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 614 (Automatic Transmission - F250-F550 Super Duty) >> In-Vehicle Repair >> Output Shaft Speed (OSS) Sensor >> Removal

Output Shaft Speed (OSS) Sensor: Removal

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the output shaft speed (OSS) sensor.
    Fig 1: Identifying Output Shaft Speed (OSS) Sensor Electrical Connector
    G03889074Courtesy of FORD MOTOR CO.

    3. 4x4 vehicles 

    NOTE: Prior to removing the speed sensor, make sure that the area around the sensor is free of debris to prevent contamination of the transmission.
  3. Remove the OSS sensor.
    1. Remove the bolt.
    2. Remove the OSS sensor.
      Fig 2: Identifying OSS Sensor (4x4 Vehicles)
      G04649616Courtesy of FORD MOTOR CO.

    4. 4x2 vehicles 

    NOTE: Prior to removing the speed sensor, make sure that the area around the sensor is free of debris to prevent contamination of the transmission.
  4. Remove the OSS sensor.
    1. Remove the bolt.
    2. Remove the OSS sensor.
      Fig 3: Identifying OSS Sensor (4X2 Vehicles)
      G04649617Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals