LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 614 (Automatic Transmission - F250-F550 Super Duty) >> In-Vehicle Repair >> Internal Harness Service >> Installation

Internal Harness Service: Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Push the bulkhead connector through the transmission solenoid body, twist it to lock it in place.
  2. Connect the internal wiring harness.
    1. Install the 2 screws.
    2. Connect the transmission fluid temperature sensor electrical connector.
    3. Connect the solenoid electrical connectors.
      Fig 1: Identifying Solenoid Electrical Connectors
      G04649670Courtesy of FORD MOTOR CO.
    3. NOTE: The O-ring seal must be installed in the top slot.
    Fig 2: Identifying Bulkhead Connector O-Ring
    G03889120Courtesy of FORD MOTOR CO.
  3. Install a new solenoid body bulkhead connector O-ring seal and lubricate it with clean automatic transmission fluid.
  4. Install the solenoid body assembly. For additional information, refer to SOLENOID BODY ASSEMBLY .
scientia non olet · About LEMON Manuals