LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 614 (Automatic Transmission - F250-F550 Super Duty) >> In-Vehicle Repair >> Extension Housing Seal >> Removal

Extension Housing Seal: Removal

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. Remove the driveshaft. For additional information, refer to DRIVESHAFT .

    2. Four wheel drive (4WD) vehicles 

  2. Remove the transfer case. For additional information, refer to TRANSFER CASE .

    3. Vehicles with a fixed flange 

  3. Remove the output shaft flange.
    1. Remove and discard the output shaft flange bolt.
    2. Remove the output shaft flange.
      Fig 1: Identifying Output Shaft Flange And Bolt
      G04615854Courtesy of FORD MOTOR CO.
  4. Using the special tool, remove and discard the output shaft nut.
    Fig 2: Identifying Output Shaft With Special Tool
    G04649634Courtesy of FORD MOTOR CO.
  5. Using the special tools, remove the output shaft seal.
    Fig 3: Removing Output Shaft Seal
    G04649630Courtesy of FORD MOTOR CO.

    6. Vehicles without a fixed flange 

  6. Using the special tools, remove the extension housing seal.
    Fig 4: Identifying Extension Housing Seal
    G04649631Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals