Catalytic Converter - Gasoline Engines: Installation
WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Do not tighten any fasteners until all components are aligned.
- If removed, install the catalyst monitor sensor.
- Tighten to 46 Nm (34 lb-ft).
- Clean the mating surface of the exhaust Y-pipe flange-to-catalytic converter flange gasket.
- Position the catalytic converter and connect the rubber isolator.
- If equipped, connect the exhaust intermediate pipe isolator and the front muffler isolator.
- Install a new exhaust Y-pipe flange gasket, and install loosely new exhaust Y-pipe flange nuts.
- Place the new coupling on the catalytic converter-to-muffler joint or, if equipped, catalytic converter-to-exhaust intermediate pipe joint. Make sure the coupling is installed no more the 4 mm (0.15 in) from the back of the button on the end of the pipe.
- Align the exhaust system. For additional information refer to EXHAUST SYSTEM ALIGNMENT .
- Tighten the exhaust Y-pipe flange nuts.
- Tighten to 40 Nm (30 lb-ft).
- Tighten the catalytic converter-to-muffler coupling or, if equipped, catalytic converter-to-exhaust intermediate pipe coupling.
- Tighten to 55 Nm (41 lb-ft).
- If equipped, install the skid plate.
NOTE:
Apply anti-seize to the threads of the catalyst monitor sensor before installation.
NOTE:
Using an abrasive pad, clean the exhaust coupling surface area of any surface rust.