Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the electrical connector.

Fig 1: Locating Vacuum Pump Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the bolts.
- To install, tighten to 11 Nm (8 lb-ft).
  
  Fig 2: Locating Bolts
  Courtesy of FORD MOTOR CO.
Disconnect the vacuum hose and remove the vacuum pump and bracket.

Fig 3: Locating Vacuum Pump And Bracket
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.