LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 608 (Engine - 5.4L (3V) - F250 & F350) >> In-Vehicle Repair >> Valve Cover - RH >> Installation

Valve Cover - RH: Installation

WARNING: This page is about a different car, the 2006 Ford Pickup and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: If the valve cover is not secured within 4 minutes, the sealant must be removed and the sealing area cleaned with silicone gasket remover and metal surface prep. Follow the directions on the packaging. Allow to dry until there is no sign of wetness, or 4 minutes, whichever is longer. Failure to follow this procedure can cause future oil leakage.
    Fig 1: Applying Bead Of Silicone Gasket And Sealant In 2 Places Where Engine Front Cover Meets Cylinder Head
    G03919863Courtesy of FORD MOTOR CO.
  1. Apply a bead of silicone gasket and sealant in 2 places where the engine front cover meets the cylinder head.
  2. Position the LH valve cover and new gasket on the cylinder head and tighten the bolts in the sequence shown.
    • Tighten to 10 Nm (89 lb-in).
      Fig 2: Identifying Tightening Sequence Of Valve Cover Bolts
      G03919864Courtesy of FORD MOTOR CO.
  3. Connect the wiring harness retainers to the valve cover.
  4. Position the evaporative emissions (EVAP) canister purge valve assembly and install the 3 nuts.
    • Tighten to 10 Nm (89 lb-in).
      Fig 3: Locating Evaporative Emissions Canister Purge Valve Bracket Nuts
      G03919862Courtesy of FORD MOTOR CO.
  5. Connect the EVAP vapor tube quick connect couplings and the EVAP canister purge valve electrical connector. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION - GASOLINE AND DIESEL .
    Fig 4: Connecting Electrical Connector And EVAP Tube Quick Connect Couplings
    G03919866Courtesy of FORD MOTOR CO.
  6. Connect the engine wiring harness retainer to the EVAP canister purge valve bracket.
    Fig 5: Engine Wiring Harness Retainer
    G03919860Courtesy of FORD MOTOR CO.
  7. Connect the crankcase vent tube quick connect coupling to the valve cover. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION - GASOLINE AND DIESEL .
  8. Install the RH ignition coils. For additional information, refer to ENGINE IGNITION - 5.4L AND 6.8L (3V) .
  9. Install the RH VCT oil control solenoid. For additional information, refer to ELECTRONIC ENGINE CONTROLS - GASOLINE ENGINES .
  10. If equipped, install the transmission filler tube. For additional information, refer to AUTOMATIC TRANSAXLE/TRANSMISSION - TORQSHIFT .
scientia non olet · About LEMON Manuals