Contour (Fuel Line Venting)
WARNING: This page is about a different car, the 2000 Ford Pickup, 2000 Ford Econoline, and 2000 Ford Contour. However, it is still accessible from the selected car via links, so may be relevant.
- Place ALT/GAS mode switch in ALT mode (CNG). DO NOT close the quarter turn valve. Remove fuel cylinder shield from trunk area. Disconnect electrical connector from fuel cylinder. Start and run engine at idle until engine automatically switches over to GAS mode.
- Run engine, if necessary, at high idle (about 1500 RPM) to encourage ALT/GAS switchover. ALT/GAS switchover should occur within 60 seconds. Once engine switches over or stalls, disconnect negative battery cable. Raise and support the vehicle. Slowly open fitting that requires servicing and allow any trapped gas to escape.