Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Only vehicles with a mechanical shift transfer case are equipped with a mode indication switch.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Disconnect the wiring harness connector.

Fig 1: Locating Wiring Harness Connector
Courtesy of FORD MOTOR CO.
Remove the mode indication switch.
- To install, tighten to 31 Nm (23 lb-ft).
To install, reverse the removal procedure.