LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 596 (Transfer Case - Four Wheel Drive (4WD) Systems -- F250-F550 Super Duty) >> Removal And Installation >> Hublock >> Installation

Removal And Installation: Hublock: Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. Install a new gasket and O-ring on the hublock.
    Fig 1: Locating Gasket And O-Ring
    G04650805Courtesy of FORD MOTOR CO.
  2. Rotate the hublock dial clockwise to the LOCK position, then apply the specified grease to the inner and outer splines.
    Fig 2: Locating Inner And Outer Splines
    G04650806Courtesy of FORD MOTOR CO.
    3. NOTE: Wiggle the axle shaft while sliding the hublock on the splines to ease installation.
  3. Slowly rotate the wheel hub while installing the hublock into the hub.
    • Push the hublock in firmly by hand to seat the O-ring seal completely.
  4. Rotate the hublock dial counterclockwise to the AUTO position.
    • Be sure that the axle shaft turns freely.
  5. Tighten the new hublock screws to 6 Nm (53 lb-in).

    6. Dual rear wheel vehicles 

  6. Install the front wheel hub extender and nuts.
    • Tighten to 176 Nm (130 lb-ft).
      Fig 3: Locating Front Wheel Hub Extender Nuts
      G04650807Courtesy of FORD MOTOR CO.
  7. Install the rear wheels and tires. For additional information, refer to WHEELS & TIRES .
scientia non olet · About LEMON Manuals