LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 594 (Driveshaft -- F250-F550 Super Duty) >> Disassembly And Assembly >> Driveshaft Slip Yoke >> Disassembly

Driveshaft Slip Yoke: Disassembly

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Do not clamp the driveshaft in the jaws of a vise or a similar holding fixture.
  1. Place the driveshaft on a suitable workbench.
  2. Index-mark the driveshaft slip yoke and the stub shaft.
    Fig 1: Locating Index-Mark Driveshaft Slip Yoke And Stub Shaft
    G04643382Courtesy of FORD MOTOR CO.
  3. Remove the driveshaft slip yoke.
    1. Cut and discard the driveshaft slip yoke boot clamps.
    2. Separate the driveshaft slip yoke from the stub shaft.
      Fig 2: Removing Driveshaft Slip Yoke
      G04643383Courtesy of FORD MOTOR CO.
  4. Remove and discard the driveshaft slip yoke boot.
    Fig 3: Removing Driveshaft Slip Yoke Boot
    G04643384Courtesy of FORD MOTOR CO.
  5. Check the lubricant for contamination. If the lubricant feels gritty, clean and inspect the stub shaft and driveshaft slip yoke for wear. Install new components as necessary.
    Fig 4: Locating Stub Shaft And Driveshaft Slip Yoke For Wear
    G04643385Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals