LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 588 (Rear Disc Brake System -- F250-F550 Super Duty) >> Removal And Installation >> Rear Brake Caliper Anchor Plate >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the brake pads. For additional information, refer to BRAKE PADS .
  2. Remove the 2 brake caliper anchor plate bolts and the brake caliper anchor plate.
    • To install (F-250, F-350 single rear wheel caliper), tighten to 275 Nm (203 lb-ft).
    • To install (F-350 dual rear wheel caliper), tighten to 275 Nm (203 lb-ft).
    • To install (F-450, F-550 dual rear wheel caliper), tighten to 400 Nm (295 lb-ft).
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals