LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 587 (Front Disc Brake System -- F250-F550 Super Duty) >> Removal And Installation >> Front Brake Caliper Anchor Plate >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the brake pads. For additional information, refer to BRAKE PADS .
  2. Remove and discard the 2 brake caliper anchor plate bolts.
    • To install (F-250, F-350), tighten to 225 Nm (166 lb-ft).
    • To install (F-450, F-550), tighten to 400 Nm (295 lb-ft).
  3. Inspect the brake caliper anchor plate assembly.
    • Check the guide pin boots for damage.
    • Check the guide pins for binding and damage.
    • If pins are worn or damaged, install new pins. Lubricate the pins with silicone grease.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals