LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 562 (Electronic Engine Control System - 3.0L (4V)) >> Removal And Installation >> Crankshaft Position (CKP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  3. Remove the 5 bolts and the RH splash shield.
    • To install, tighten to 9 Nm (80 lb-in).
  4. Disconnect the crankshaft position (CKP) sensor electrical connector.
  5. Remove the bolt and the CKP.
    • To install, tighten to 10 Nm (89 lb-in).
    • Inspect the O-ring seal and install new as necessary.
    6. NOTE: Lubricate the CKP O-ring seal with clean engine oil.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals