LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 552 (Engine Emission Control - 3.0L (4V)) >> Removal And Installation >> Exhaust Gas Recirculation (EGR) Vacuum Regulator Valve >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the exhaust gas recirculation (EGR) vacuum regulator valve electrical connector.
  3. Disconnect the vacuum tube fittings from the EGR vacuum regulator valve.
  4. Remove the nut and detach the wiring retainer from the EGR vacuum regulator valve stud bolt.
    • To install, tighten to 6 Nm (53 lb-in).
  5. Remove the 2 stud bolts and the EGR vacuum regulator valve.
    • To install, tighten to 6 Nm (53 lb-in).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals