LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 541 (Hydraulic Brake System Actuation) >> Removal And Installation >> Brake Pedal and Bracket >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the brake pedal position (BPP) switch. For additional information, refer to EXTERIOR LIGHTING .
  3. On speed-control equipped vehicles, remove the speed-control deactivator switch. For additional information, refer to SPEED CONTROL .
  4. Remove the brake booster pushrod pin redundant clip.
  5. Remove the brake pedal self-locking pin.
  6. Remove the brake booster pushrod outer bushing.
  7. Slide the brake booster pushrod off the brake pedal pin and position the pushrod aside.
  8. Remove the brake booster pushrod inner bushing.
  9. Remove the brake pedal bracket upper bolt.
    • To install, tighten to 23 Nm (17 lb-ft).
  10. Remove the brake pedal bracket upper nut.
    • To install, tighten to 23 Nm (17 lb-ft).
  11. Remove the 4 brake booster nuts.
    • To install, tighten to 23 Nm (17 lb-ft).
  12. Remove the brake pedal and bracket assembly.
    • Position the brake booster forward to allow the brake pedal and bracket assembly to clear the brake booster studs.
  13. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals