Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
- Disconnect the ignition coil electrical connectors.
- Remove the bolts and the ignition coils.
- To install, tighten to 8 Nm (71 lb-in).
- To install, reverse the removal procedure.
- Apply a small amount of dielectric grease to the inside of the ignition coil boots before attaching to the spark plugs.