Parameter Reset and Programming Keys

WARNING: This page is about a different car, the 2002 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The instrument cluster parameters must be reset upon installation of a new instrument cluster.

NOTE: Both passive anti-theft system (PATS) keys are needed to carry out this procedure.

To reset the instrument cluster parameters and programming keys, complete the following procedure:

Connect the diagnostic tool.
Select powertrain control module (PCM).
Select ENTER SECURITY ACCESS. Wait 10 minutes for security access to be granted.
Select PARAMETER RESET.
Select the instrument cluster.
Select ENTER SECURITY ACCESS. Wait 10 minutes for security access to be granted.
Select PARAMETER RESET.
Disconnect the diagnostic tool.
Place ignition key in the OFF position.
Place ignition key in the RUN position.
Remove the ignition key.
Place the second PATS key in the RUN position.
Place the ignition key in the OFF position.