LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 507 (HVAC Control System) >> Removal And Installation >> Floor Duct - Rear Seat >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the driver and front passenger seats. For additional information, refer to SEATING .
  2. Remove the floor console. For additional information, refer to REMOVAL AND INSTALLATION .
  3. Remove the front door scuff plate trim panels and the lower A-pillar trim panels. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  4. Pull back the carpeting to gain access to the floor ducts.
  5. Separate the wiring harness from the floor ducts and position aside.
  6. Remove the floor duct.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals