Removal & Installation (3.3L Villager)
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2000 Mercury Villager, 2000 Mercury Mountaineer, 2000 Lincoln Navigator, 2000 Ford Windstar, and 2000 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
Remove air cleaner and duct assembly. Partially drain cooling system. Disconnect accelerator cables, electrical connectors and hoses from throttle body. Remove 4 bolts and throttle body. Clean gasket mating surfaces. To install, reverse removal procedure using NEW gasket. Tighten bolts to specification. See TORQUE SPECIFICATIONS .