Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Remove the engine coolant degas bottle. For additional information, refer to REMOVAL AND INSTALLATION ALL VEHICLES .
Install the special tool.

Fig 1: Using Special Tool (303-F072) To Raise Engine
Courtesy of FORD MOTOR CO.
Remove the engine mount bracket bolt.
- To install, tighten to 115 N.m (85 lb-ft).
Use the special tool to raise the engine 25 mm (0.98 in).

Fig 2: Using Special Tool (303-F072) To Raise Engine
Courtesy of FORD MOTOR CO.
Remove the 2 nuts and the engine mount bracket.
- To install, tighten to 115 N.m (85 lb-ft).
Remove the 3 bolts and the engine mount.
- To install, tighten to 55 N.m (41 lb-ft).
To install, reverse the removal procedure.