LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Telematics) >> Removal And Installation >> Telematics Control Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2002 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the sun visors from each side.
    Fig 1: Removing Sun Visors
    G01275015Courtesy of FORD MOTOR CO.
  2. Remove the assist handle.
    Fig 2: Removing Assist Handle
    G01275016Courtesy of FORD MOTOR CO.
  3. Remove the windshield garnish moldings.
    Fig 3: Removing Windshield Garnish Moldings
    G01275017Courtesy of FORD MOTOR CO.
  4. Remove the upper B-pillar trim.
    Fig 4: Removing Upper B-Pillar Trim
    G01275018Courtesy of FORD MOTOR CO.
  5. Remove the front dome lamp assembly bezel.
  6. Carefully pull the front of the headliner down to gain access to the telematics control switch.
    NOTE: Folding the headliner will require installing a new headliner.
  7. Remove the telematics control switch.
    1. Remove the screws.
    2. Disconnect the electrical connector.
    Fig 5: Removing Telematics Control Switch
    G01275019Courtesy of FORD MOTOR CO.
  8. To install, reverse the removal procedure.