Removal and Installation

WARNING: This page is about a different car, the 2002 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

Remove the cellular phone antenna base.
CAUTION: To avoid damage to the glass, do not pry the antenna base when removing.
1. Disconnect the antenna cable.
2. Cut the two-way tape holding the cellular phone antenna base to the glass.
Fig 1: Removing Cellular Phone Antenna Base
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
NOTE: Before applying new two-way tape to install the cellular phone antenna base, use Ultra-Clear Spray Glass Cleaner E4AZ-19C507-AA meeting Ford specification ESR-M14P5-A or equivalent to thoroughly clean the glass.

NOTE: Inside and outside antenna bases must be carefully and accurately aligned so they do not cover any heater wire grids.

NOTE: The coaxial cable connector must be installed toward the right of the vehicle.