LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 460 (Seat System) >> Removal And Installation >> Seat Armrest - Rear >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: If equipped with fire suppression system, depower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM .
  1. For police vehicles equipped with a fire suppression system, depower the system.
  2. Remove the rear seat cushion and backrest. For additional information, refer to SEAT - REAR .
  3. Remove the 4 nuts.
    • To install, tighten to 5 Nm (44 lb-in).
  4. Remove the armrest.
    5. WARNING: The retaining wire in the rear seat cushion pad and frame and rear seat backrest pad and frame back must be fully seated in the retainer brackets to prevent the seat backrest and seat cushion from sliding forward in the event of a collision. Failure to follow these instructions may result in personal injury.
  5. To install, reverse the removal procedure.
    • Make sure the safety belts and buckles are accessible to the occupants after installation.
    • Verify the safety belt retractor operates without excessive effort or binding.
    6. WARNING: If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM .
  6. For police vehicles equipped with a fire suppression system, repower the system.
scientia non olet · About LEMON Manuals