LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 458 (Exterior Trim And Ornamentation) >> Removal And Installation >> License Plate Housing >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. Remove the 8 license plate housing nuts.
  2. Disconnect the license plate housing electrical connector.
  3. Remove the 2 screws and the license plate.

    4. Grand Marquis 

  4. Remove the 2 screws and the license plate housing.
    Fig 1: Removing Screws And License Plate Housing
    G04585799Courtesy of FORD MOTOR CO.

    5. Crown Victoria 

  5. Remove the 4 screws and the license plate housing.
    Fig 2: Removing Screws And License Plate Housing
    G04585800Courtesy of FORD MOTOR CO.

    6. All vehicles 

  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals