LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 455 (Body Panel System - Front End Body Panels) >> Removal And Installation >> Fender Splash Shield - RH >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: If equipped with fire suppression system, depower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM .
  1. Remove the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the battery tray bolt.
    • To install, tighten to 12 Nm (9 lb-ft).
  3. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  4. Remove the 2 bolts and the fender splash shield.
    • To install, tighten to 12 Nm (9 lb-ft).
    5. WARNING: If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM .
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals