Brake Booster: Removal
WARNING: This page is about a different car, the 2002 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the wiper arm nuts and remove wiper arms.
- Disconnect the washer hose.
- Remove the cowl cover.
- Remove the cowl cover pushpins.
- Remove the cowl cover rubber trim.
- Remove the cowl cover.
- Remove the vacuum hose bracket nut and position bracket aside.
- Remove the cowl brace center bolts.
- Remove the cowl brace end bolts and remove the bracket.
- Disconnect the coolant reservoir return hose.
- Remove the brake master cylinder. For additional information, see MASTER CYLINDER .
- Disconnect the power brake booster check valve.
- Disconnect the power brake booster electrical connector (as applicable).
- Remove the coolant reservoir bolts.
- Disconnect the radiator to engine vent.
- Remove the coolant reservoir.
- Remove the clip from the brake pedal pin.
- Remove the brake pedal pin.
- Remove the booster nuts.
- Remove the power brake booster.