LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Front Suspension - 2WD - Excursion, F-250 & F-350 Super Duty) >> Removal & Installation >> Spindle >> Installation

Removal & Installation: Spindle: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Ford Pickup, 2004 Ford Excursion, 2003 Ford Pickup, 2003 Ford Excursion, and 2002 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure ball joint seals are in position. Place spindle and ball joints into axle. Install lower ball joint nut and tighten to specification. See TORQUE SPECIFICATIONS .
  2. Install camber adjuster over upper ball joint stud. Ensure camber adjuster is properly aligned. If camber adjustment is required, special camber adjusters must be installed. Tap camber adjuster into spindle. Tighten upper ball joint nut to specification.
  3. Install cotter pin. Install axle clamp bolt and tighten to specification. To complete installation, reverse removal procedure. Adjust wheel bearings. See WHEEL BEARING ADJUSTMENT  under ADJUSTMENTS & INSPECTION. Check wheel alignment. See SUSPENSION SYSTEM - GENERAL INFORMATION . Tighten bolts and nuts to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals