LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 369 (Bumpers) >> Removal And Installation >> Front Bumper >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front bumper cover. For additional information, refer to FRONT BUMPER COVER  in this article.
  2. Remove the front bumper isolator.
    3. NOTE: Spot welding the bumper is not required for installation.
  3. Drill out the 6 front bumper spot welds.
  4. Remove the 8 bolts and the front bumper.
    • To install, tighten the 6 front bumper bolts to 25 Nm (18 lb-ft).
    • To install, tighten the 2 front bumper bolts to 10 Nm (89 lb-ft).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals