Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: When any new lock cylinder is installed, the luggage compartment lid lock cylinder, the driver door lock cylinder, and ignition lock cylinder should be installed as a set. This eliminates carrying an extra key that fits only 1 lock. If a new key is used, the new key code number is stamped on a metal tag attached to the key.

NOTE: Individual lock cylinders are repaired by discarding the inoperative cylinder and building a new lock cylinder using the appropriate lock repair package. The lock repair package includes a detailed instruction sheet to build the new lock cylinder to the current key code of the vehicle.

Disconnect the battery and wait at least 1 minute to allow for depletion of the restraint system back up power supply. For additional information refer to BATTERY, MOUNTING AND CABLES .
Remove the steering column cover. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
Remove the inner instrument panel finish panel.
Turn the ignition switch to the RUN position.
Using a small flat-blade screwdriver, press and hold the ignition lock cylinder release button.
Remove the ignition lock cylinder.
To install, reverse the removal procedure.
- Lubricate the ignition lock cylinder before installation.