Removal and Installation
WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
- Remove the 2 door check arm screws.
- To install, tighten to 12 Nm (9 lb-ft)
- Remove the 4 screws and the speaker.
- Disconnect the electrical connector.
- Remove the nuts and the door check arm.
- To install, tighten to 12 Nm (9 lb-ft)
CAUTION:
Do not close the door after removal of the check arm screws.