Side Crash Sensor: Installation
WARNING: This page is about a different car, the 2002 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
- Position side crash sensor in vehicle and install mounting bolts. Tighten sensor mounting bolts to specification. See TORQUE SPECIFICATIONS . Connect side crash sensor electrical connector. Connect negative battery cable. With air bag simulators installed at all deployable air bag system devices, perform system operation check. See SYSTEM OPERATION CHECK . Disconnect negative battery cable. Wait at least one minute for back-up power supply to deplete stored energy.
- To complete installation, reverse removal procedure. Tighten fasteners to specification. Activate air bag system. See ACTIVATING SYSTEM under DISABLING & ACTIVATING AIR BAG SYSTEM.