LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 325 (Automatic Transaxle/Transmission) >> Diagnosis And Testing >> Diagnosis By Symptom >> Diagnostic Routines >> Other Concern: Slip/Chatters in Manual 3rd Position

Other Concern: Slip/Chatters in Manual 3rd Position

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
OTHER CONCERN: SLIP/CHATTERS IN MANUAL 3RD POSITION

Possible Component Reference/Action
282 - ROUTINE 
Powertrain Control System   
  • PCM, vehicle wiring harnesses, Pressure Control Solenoids A, B
  • Carry out on-board diagnostic tests. See INTRODUCTION - GASOLINE article for diagnosis and testing of the PCM.
  • GO to PINPOINT TEST D .
  • Repair as required. Clear DTCs, road test and rerun on-board diagnostic test.
Fluid   
  • Incorrect level
  • Condition
Incorrect Pressures   
  • High/low pressures
OD Servo   
  • Servo retaining screws damaged
  • Inspect for damage. Repair as necessary.
  • Seals (piston and cover) damaged
  • Inspect for damage. Repair as necessary.
OD Band   
  • Band damaged
  • Inspect for damage. Repair as necessary.
  • Servo worn or damaged
  • Inspect for damage. Repair as necessary.
  • Not adjusted correctly
  • Inspect for damage. Repair as necessary.
Intermediate Servo   
  • Servo retaining screws damaged
  • Inspect for damage. Repair as necessary.
  • Seals (piston and cover) damaged
  • Inspect for damage. Repair as necessary.
Intermediate Band   
  • Band damaged
  • Inspect for damage. Repair as necessary.
  • Servo worn or damaged
  • Inspect for damage. Repair as necessary.
  • Not adjusted correctly
  • Inspect for damage. Repair as necessary.
Forward Clutch Assembly   
  • Seals, piston damaged
  • Inspect for damage. Repair as necessary.
  • Check ball damaged, missing, not seating, off location
  • Inspect for mislocation, poor seating, damage. Install a new cylinder.
  • Friction elements damaged or worn
  • Inspect for damage. Repair as necessary.
  • Return springs damaged
  • Inspect for damage. Repair as necessary.
  • Bronze seal ring or bearing damaged
  • Inspect for damage. Repair as necessary.
Direct One-way Clutch   
  • Worn, damaged or assembled incorrectly
  • Inspect for damage. Repair as necessary.
Low One-way Clutch   
  • Worn, damaged or assembled incorrectly
  • Inspect for damage. Repair as necessary.