Engagement Concern: Delayed or Soft Reverse ONLY

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

ENGAGEMENT CONCERN: DELAYED OR SOFT REVERSE ONLY

Possible Component	Reference/Action
205 - ROUTINE
Powertrain Control System
PCM, vehicle wiring harnesses, Pressure Control Solenoid C (PC C)	Carry out on-board diagnostic tests. For additional information, See INTRODUCTION - GASOLINE article for diagnosis and testing of the PCM. GO to PINPOINT TEST D . Repair as required. Clear DTCs, road test and rerun on-board diagnostic test.
Incorrect pressures
Low pressure	Check pressure at line and PC C taps. Carry out Line Pressure Test. Refer to SPECIAL TESTING PROCEDURES in this article.
Main Control
Screws not tightened to specification	Tighten to specification.
Separator plate damaged	Inspect for damage. If damaged, install a new separator plate.
Contamination	Disassemble and clean.
Valves, springs damaged, misassembled, missing, stuck or bore damaged	If damaged or parts are missing, install a new main control assembly. If misassembled, reassemble correctly. DO NOT stone, file or sand valves. This will remove the anodized finish and may result in further main control or transmission damage.
Filter damaged, missing	Inspect for damage, repair as necessary.
Direct Clutch Assembly
Seals, piston damaged	Inspect for damage. Repair as necessary.
Check ball damaged, missing not seating, off location	Inspect for mislocation, poor seating, damage. Install a new cylinder.
Friction elements damaged or worn	Inspect for damage. Repair as necessary.
Return springs damaged	Inspect for damage. Repair as necessary.
Reverse Servo
Servo retaining screws damaged	Inspect for damage. Repair as necessary.
Seals (piston and cover) damaged	Inspect for damage. Repair as necessary.
Reverse Band
Band damaged	Inspect for damage. Repair as necessary.
Servo worn or damaged	Inspect for damage. Repair as necessary.