Removal and Installation
WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
- Disconnect the crankshaft position (CKP) sensor electrical connector.
- Remove the bolt and the CKP sensor.
- To install, tighten to 10 Nm (89 lb-in).
- Inspect and install a new O-ring seal as necessary.
- To install, reverse the removal procedure.
NOTE:
Lubricate the O-ring seal with clean engine oil.