Removal and Installation
WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
- Remove the engine appearance cover and the noise suppressor (if detached).
- Disconnect the 2 camshaft position (CMP) sensor electrical connectors.
- Remove the ground strap nut and position the ground strap aside.
- To install, tighten to 10 Nm (89 lb-in).
- Remove the 3 nuts and position the wiring harness conduit aside.
- To install, tighten to 8 Nm (70 lb-in).
- Remove the 2 bolts and the LH and RH CMP sensors.
- To install, tighten to 10 Nm (89 lb-in).
- Inspect and install new O-ring seals as necessary.
- To install, reverse the removal procedure.
CAUTION:
The engine appearance cover is equipped with a noise suppressor. If the noise suppressor becomes separated from the engine appearance cover it must be positioned on the intake manifold prior to installing the engine appearance cover.
NOTE:
Lubricate the O-ring seals with clean engine oil.