LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 314 (Engine - 3.0L (4V)) >> In-Vehicle Repair >> Crankshaft Pulley >> Removal

Crankshaft Pulley: Removal

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the accessory drive belt. For additional information, refer to ACCESSORY DRIVE .
  3. Remove the front center splash shield.
  4. Using the special tool to hold the crankshaft pulley, remove and discard the bolt.
    Fig 1: Holding Crankshaft Pulley Using Special Tool
    G03995763Courtesy of FORD MOTOR CO.
    5. CAUTION: The special tool must grab the inside of the damper or damage to the damper can occur.
  5. Using the special tool, remove the crankshaft pulley.
Fig 2: Removing Crankshaft Pulley
G03995764Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals