LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 313 (Engine System-General Information) >> General Procedures >> Camshaft End Play - OHC Engines

Camshaft End Play - OHC Engines

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
CAMSHAFT END PLAY SPECIAL TOOL - OHC ENGINES

G03878636
 Dial Indicator Gauge with Holding Fixture 100-002 (TOOL-4201-C) or equivalent
  1. Use a Dial Indicator Gauge with Holding Fixture to measure camshaft end play.
  2. Position the camshaft to the rear of the cylinder head.
  3. Zero the indicator.
  4. Move the camshaft to the front of the cylinder head. Note and record the camshaft end play.
    • If camshaft end play exceeds specifications, install new camshaft and recheck end play. Refer to the appropriate article for the procedure.
    • If camshaft end play exceeds specification after camshaft installation, install a new cylinder head. Refer to the appropriate article for the procedure.
    Fig 1: Using Dial Indicator Gauge With Holding Fixture To Measure Camshaft End Play
    G03885002Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals