LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 304 (Rear Disc Brakes) >> Removal And Installation >> Rear Brake Caliper >> Removal

Rear Brake Caliper: Removal

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Use of any other than approved DOT 3 or DOT 4 brake fluid will cause permanent damage to brake components and will render the brakes inoperative.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately.
CAUTION: Brake fluid is harmful to painted or plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the parking brake cable end from the parking brake lever arm.
    Fig 1: Locating Parking Brake Cable End
    G03995453Courtesy of FORD MOTOR CO.
  3. Disconnect the parking brake cable and conduit from the brake caliper.
    Fig 2: Identifying Parking Brake Cable And Conduit At Brake Caliper
    G03995454Courtesy of FORD MOTOR CO.
  4. Remove the brake caliper flow bolt and discard the 2 copper washers.
    Fig 3: Identifying Brake Caliper Hose Bolt
    G03995455Courtesy of FORD MOTOR CO.
  5. Remove the 2 brake caliper bolts.
  6. Remove the brake caliper.
  7. Inspect the disc brake caliper.
    • If leaks or damaged boots are found, install a new disc brake caliper.