Rear Brake Caliper: Installation
WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
- Position the brake caliper and install the 2 bolts.
- Tighten to 35 Nm (26 lb-ft).
- Using 2 new copper washers, position the front brake flexible hose and install the flow bolt.
- Tighten to 47 Nm (35 lb-ft).
- Connect the parking brake cable and conduit to the brake caliper.
- Install the parking brake cable end to the parking brake lever arm.
- Bleed the caliper. For additional information, refer to BRAKE SYSTEM-GENERAL INFORMATION .