Wheel Studs: Removal

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Suspension fasteners are critical parts because they affect the performance of vital components and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation becomes necessary. Do not use a new part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.

Remove the front brake disc. For additional information, refer to FRONT DISC BRAKE .
Using the special tool, press the stud from the flange.

Fig 1: Pressing Stud From Flange
Courtesy of FORD MOTOR CO.
Line up the stud with the hole in the wheel knuckle and remove the stud.

Fig 2: Lining Up Stud With Hole In Wheel Knuckle

Courtesy of FORD MOTOR CO.