LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 265 (Interior Trim And Ornamentation) >> Removal And Installation >> B-Pillar Trim Panel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Depower the supplemental restraint system (SRS). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
  2. Remove the lower B-Pillar trim panel.
    • Pull the lower B-Pillar trim panel toward the center of the vehicle to release the retaining clips.
  3. Position the front seat forward for access.
  4. Remove the front safety belt anchor-to-seat nut cover.
  5. Remove the front safety belt anchor-to-seat nut.
    • To install, tighten to 40 Nm (30 lb-ft).
  6. Disconnect the belt tension sensor electrical connector.
    Fig 1: Disconnecting Belt Tension Sensor Electrical Connector
    G03988613Courtesy of FORD MOTOR CO.
  7. Remove the B-pillar screw cover.
  8. Remove the B-pillar screw.
  9. Remove the upper B-pillar trim panel.
    • Pull the lower portion of the upper B-pillar trim panel toward the center of the vehicle to release the retaining clips.
    • Lower the upper B-pillar trim panel from the headliner.
    • Separate the upper B-pillar trim panel from the front safety belt.
  10. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals