LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 262 (Body Panel System - Front End Body Panels) >> Removal And Installation >> Cowl Panel Grille >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Cowl Panel Grille
G03988604Courtesy of FORD MOTOR CO.
  1. Remove the wiper pivot arms. For additional information, refer to WIPERS AND WASHERS .
  2. Remove the cowl panel grille side moulding pin-type retainers.
  3. Remove the cowl panel grille side mouldings.
  4. Disconnect the windshield washer hose connector.
  5. Remove the 4 cowl panel grille retainer clips.
  6. CAUTION: Failure to follow the removal instruction may result in damaged retaining tabs and would require removal of the windshield glass.
  7. Disconnect the cowl panel grille from the retaining strip on the cowl.
    • Spread the retaining tabs.
    • Start from the drivers side and work the cowl trim panel off, moving across the panel from the LH to the RH side to remove.
      Fig 2: Disconnecting Cowl Panel Grille From Retaining Strip On Cowl
      G03988605Courtesy of FORD MOTOR CO.
  8. Remove the cowl panel grille.
  9. To install, reverse the removal procedure.