LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Taurus LX, 3.0 2, AX4N >> Repair and Diagnosis >> External Pages >> Different car >> Section 256 (Exterior Trim And Ornamentation) >> Removal And Installation >> Rocker Panel Moulding >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the front and rear door.
  2. Position the lower door side portion of the fender moulding away from the fender.
  3. Release the lower rocker panel moulding retainers from the body, starting from the front of the vehicle moving rearward.
  4. Release the upper rocker panel moulding retainers from the body, starting from the front of the vehicle moving rearward.
  5. Remove the rocker panel moulding.
  6. To install, reverse the removal procedure.
    • It is necessary to install new rocker panel moulding retainer clips anytime the rocker panel moulding is serviced.
scientia non olet · About LEMON Manuals