Removal and Installation
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the brake master cylinder. For additional information, refer to HYDRAULIC BRAKE ACTUATION .
- Disconnect the brake booster vacuum fitting and position aside.
- Remove the redundant self-locking pin cover and the self-locking pin.
- Remove the booster rod and washer from the brake pedal.
- Remove and discard the 4 nuts and the brake booster.
- To install, tighten to 25 Nm (18 lb-ft).
- To install, reverse the removal procedure.