Manual Bleeding
WARNING: This page is about a different car, the 2001 Lincoln LS and 2000 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
- Connect NGS DCL cable adapter into vehicle data link connector (DCL) underneath dash, and follow NGS instructions. Clean dirt from around master cylinder, and remove cap. Fill master cylinder.
- Place box end wrench onto right rear bleeder screw. Attach rubber drain tube onto bleeder screw, and submerge other end of tube into clear container partially filled with clean brake fluid. Have assistant hold firm pressure on brake pedal. Loosen bleeder screw until stream of fluid comes out. While assistant maintains pressure on pedal, tighten bleeder screw. Repeat until clear, bubble-free fluid comes out. Refill master cylinder as necessary. Tighten bleeder screw to specification. See TORQUE SPECIFICATIONS .
- Repeat step 2 for other bleeder screws. See BRAKELINE BLEEDING SEQUENCE .
BRAKELINE BLEEDING SEQUENCE
| Application | Sequence |
|---|---|
| Lincoln LS | RR, LR, RF, LF |